Distribution box manufacturers teach you how to fix the distribution box

Nowadays, you can often see the figure of the power distribution box in daily life production, especially on many construction sites, more or less always have the existence of the distribution box. However, what is worrying is that the use of many distribution boxes is now not standardized, and many people think they are experienced and do not follow the specifications in many aspects, forming a lot of safety hazards. The following distribution box manufacturers teach you the method of fixing the distribution box.

When fixing a brightly installed electrical distribution box on a concrete or brick wall, use both dark distribution pipes and dark distribution boxes and bright distribution pipes. If the distributor, first clean the box of debris, then stretch straight, branch and phase sequence distinction, according to the slip band bundle. Distribution box to find the right location, the wire end wire a box or tray, which by using the wire end, and then one by one pressed on the equipment, while in the obvious place of PE protection grounding than pressure, and box (tray) adjustment flat fixed. Power tools, dashboard fixed plate more distribution power box is completed, the instrument calibration should be used or not use the wrong use, adjusted for the correct test launch, will be filled in the card box card parts, numbered.

If the fixing comes with a splitter box, then the box must be cleaned up before use, and will be organized inside the wire tied up according to regulations. After finding the right location, put the ends of the wires into the box and crimp them to the corresponding locations one by one according to the regulations. Do not forget is to PE protection ground crimp in a conspicuous position, not just find a corner to plug, and then the box leveling and fixed work. Many users in this step of the time is not in accordance with the specifications.